|
- Disconnect connector, and measure at harness side.
- Ignition switch: ON
- Voltage between terminal engine-ECU SGC line and body earth.
|
|
Q.
Is the check result normal?
|
|
Q.
Is the check result normal?
|
|
Repair the connector(s) or wiring harness.
|
|
|
|
- Reconfirmation of diagnosis code.
|
|
Q.
Is diagnosis code stored?
|
|
Intermittent malfunction (Refer to GROUP 00 - How to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunctions ).
|
|
|
|
- Disconnect connector, and measure at harness side.
- Ignition switch: ON
- Voltage between terminal engine-ECU 5V line and body earth.
|
|
Q.
Is the check result normal?
|
|
Q.
Is the check result normal?
|
|
Repair the connector(s) or wiring harness.
|
|
|
|
- Disconnect connector, and measure at harness side.
- Resistance between terminal engine-ECU DGND line and earth.
|
|
OK: Continuity (2 Ω or less)
|
|
Q.
Is the check result normal?
|
|
Q.
Is the check result normal?
|
|
Repair the connector(s) or wiring harness.
|
|
|
|
- Use special tool test harness (MB991709) to connect connector, and measure at pick-up harness.
- Engine: Idling
- Transmission: Neutral <M/T>, P range <CVT>
- Voltage between terminal engine-ECU SGC line and body earth.
|
|
OK: Waveforms should be displayed on inspection procedure using an oscilloscope (Refer to ), its maximum value should be 4.8 V or more, and its minimum value should be 0.6 V or less. There must be no noise in the output wave pattern.
|
|
Q.
Is the check result normal?
|
|
Q.
Is the check result normal?
|
|
Repair the connector(s) or wiring harness.
|
|
|
|
Q.
Is the check result normal?
|
|
Repair the connector(s) or wiring harness.
|
|
|
|
Q.
Is the check result normal?
|
|
- Reconfirmation of diagnosis code.
|
|
Q.
Is diagnosis code stored?
|
|
Replace the camshaft position sensor.
|
|
|
|
Intermittent malfunction (Refer to GROUP 00 - How to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunctions ).
|
|
|