1.Release the fuel pressure
in the fuel line. (Refer to GROUP 13A -
On-vehicle
Service, Reduce Fuel Pressure in Pressurized Fuel Lines ![]() |
![]() |
3.Disconnect the fuel vapour
hose. |
![]() |
4.Using special tool fuel
tank cap wrench (MB992202), remove the lock nut of fuel pump
and
gauge assembly. 5.
7.
|
![]() ![]() |
8.In the same manner as
removal, use special tool fuel tank cap wrench (MB992202) to
install
the lock nut of fuel pump and gauge assembly. Tighten the lock nut so that its marking is within the shown range. 9.Connect the fuel vapour hose. 10.
(1) Make sure that the fuel pump and gauge assembly and the fuel main pipe connector remains straight. (2) Insert the connector into the fuel pump and gauge assembly until it clicks into place. 11.Connect the fuel pump and gauge assembly connector. 12.Check the fuel leak of fuel tank (Refer to ![]() 13.Install the inspection lid. 14.Install the rear seat cushion assembly (Refer to GROUP 52A - Rear Seat Assembly ![]() |