REMOVAL AND INSTALLATION


Pre-removal Operation
  • Engine Coolant Draining (Refer to ).
  • Front End Upper Bar Removal (Refer to GROUP 42A - Loose Panel ).

 Post-installation Operation
  • Front End Upper Bar Installation (Refer to GROUP 42A - Loose Panel ).
  • Engine Coolant Refilling (Refer to ).




Removal steps


1.
 Radiator drain plug


2.
 O-ring


3.
 Radiator cap


4.
 Air guide panel


5.
 Condenser tank assembly
<<A>>
 >>A<<
 6.
 Hose clip
<<A>>
 >>A<<
 7.
 Radiator upper hose
<<A>>
 >>A<<
 8.
 Hose clip
<<A>>
 >>A<<
 9.
 Radiator lower hose


·
 Water hose connection (Refer to GROUP 23A - CVT Fluid Cooler Line ) <CVT>.


10.
 Blower assembly


11.
 Cooling fan


12.
 Cooling fan motor


13.
 Cooling fan shroud
<<B>>
·
 A/C refrigerant condenser assembly (Refer to GROUP 55A - Condenser Assembly ).


14.
 Radiator

REMOVAL SERVICE POINTS

<<A>> HOSE CLIP/RADIATOR HOSE REMOVAL

1.Make mating marks on the radiator hose and the hose clip as shown to install them in the original position.

2.Break off the tip of hose clip claw and spread out the hose clip, then disconnect the radiator hose.
note If there is a hose clip claw, the hose clip cannot spread to capacity because the claw contacts the hose clip.

<<B>> A/C REFRIGERANT CONDENSER ASSEMBLY REMOVAL
1.Remove the A/C refrigerant condenser assembly together with the hose and pipe from the radiator.
2.Tie the removed A/C refrigerant condenser assembly with a string at a position where they will not interfere with the removal and installation of radiator.

INSTALLATION SERVICE POINT

>>A<< RADIATOR HOSE/HOSE CLIP INSTALLATION
1.
caution Never reuse the hose clip whose claw is broken off to prevent the rusting.
Make mating mark on a new hose clip in the same position as the remove one.

2.Insert the radiator hose until the protrusion of the pipe.
3.Align the mating marks on the radiator hose and hose clip.
4.Remove the hose clip claw and shorten the hose clip, then install the radiator hose.