REMOVAL AND INSTALLATION

<Euro2-4 (M/T)>

			Removal steps
		1.	Main muffler
		2.	Seal ring
		3.	Heat protector panel dash upper
		·	Gearshift cable and select cable assembly (Refer to GROUP 22A - Transmission Control ) <M/T>.
		·	Transmission control cable (Refer to GROUP 23A - Transmission Control ) <CVT>.
		4.	Heat protector panel front floor front
		5.	Heat protector panel front floor rear
		6.	Heat protector panel rear

<Euro2-4 (CVT) and Euro5>

			Removal steps
		1.	Main muffler
		2.	Seal ring
<<A>>	>>A<<	3.	Oxygen sensor (rear) <Except Euro2>
		4.	Catalytic converter
		5.	Seal ring
		6.	Heat protector panel dash upper
		·	Gearshift cable and select cable assembly (Refer to GROUP 22A - Transmission Control ) <M/T>.
		·	Transmission control cable (Refer to GROUP 23A - Transmission Control ) <CVT>.
		7.	Heat protector panel front floor front
		8.	Heat protector panel front floor rear
		9.	Heat protector panel rear

REMOVAL SERVICE POINT

<<A>> OXYGEN SENSOR REMOVAL

1.Remove the oxygen sensor connector connection and harness clamp.

2.Use special tool oxygen sensor wrench (MB991953) to remove the oxygen sensor.

INSTALLATION SERVICE POINT

>>A<< OXYGEN SENSOR INSTALLATION

1.In the same manner as removal, use special tool oxygen sensor wrench (MB991953) to tighten the oxygen sensor to the specified torque.
Tightening torque: 44 ± 5 N·m

2.Install the oxygen sensor connector connection and harness clamp.