REMOVAL AND INSTALLATION

Gearshift cable and select cable assembly removal steps 1. Gearshift lever knob · SRS-ECU Removal and Installation (Refer to GROUP 52B, SRS-ECU ). 2. Select cable connection (Gearshift lever side) >>B<< 3. Gearshift cable connection (Gearshift lever side) · Air Cleaner Assembly Removal and Installation (Refer to GROUP 15, Air Cleaner ). · Battery and Battery Tray Removal and Installation (Refer to GROUP 54A, Battery ). <<A>> >>A<< 4. Gearshift cable connection (Transmission side) <<A>> >>A<< 5. Select cable connection (Transmission side) <<A>> >>A<< 6. Gearshift link clip >>A<< 7. Gearshift cable and select cable assembly Gearshift lever assembly removal steps 1. Gearshift lever knob · Floor Console Removal and Installation (Refer to GROUP 52A, Floor Console Assembly ). 2. Select cable connection (Gearshift lever side) >>B<< 3. Gearshift cable connection (Gearshift lever side) 8. Gearshift lever assembly

1. caution Be careful not to pull out the cable directly to disconnect the joint because the cable could be broken. Use the clip remover (special tool: MB992277), and disconnect the joint.

2.Push up the claws of the gearshift link clip using a screwdriver, etc., and then remove the gearshift link clip from the bracket together with the cables.

1.Cross the gear shift cable and the select cable as shown and install them to the transmission.

2. caution Securely insert the clip, shift cable, and select cable until they click into place. After installing the new gearshift link clip to the cable bracket of the transmission, install the gearshift cable and select cable to the cable bracket. note The clip is reversible.

3.Securely fit the tips of the gearshift cable and the select cable. 4.Move the shift lever and gearshift lever to all positions and check that the operation is smooth.

Insert the tip of the gearshift cable to the gearshift lever assembly thoroughly as shown until it clicks in place.