REMOVAL AND INSTALLATION


caution
  • The magnetic encoder collects metallic particles easily, because it is magnetised. Make sure that the magnetic encoder should not collect metallic particles. Check that there is not any trouble prior to reassembling it.
  • When removing and installing the driveshaft assembly, make sure that the magnetic encoder (integrated with the inner oil seal) does not contact with surrounding parts to avoid damage.
  • When removing and installing the front wheel speed sensor, make sure that the pole piece at the end does not contact with surrounding parts to avoid damage.
The removal service points and installation service points are the same as before.
Pre-removal operation
  • Front under cover removal (Refer to GROUP 51 - Under Cover).
  • Transmission fluid draining (Refer to GROUP 22A - On-vehicle Service, Transmission Oil Change). <M/T>
  • CVT fluid draining (Refer to GROUP 23A - On-vehicle Service, CVT Fluid Change). <CVT>
  • Lower arm assembly and stabilizer bar connection removal (Refer to GROUP 33 - Stabilizer Bar).

 Post-installation operation
  • Using your fingers, press the ball joint dust cover to check for a crack or damage.
  • Lower arm assembly and stabilizer bar connection Installation (Refer to GROUP 33 - Stabilizer Bar).
  • CVT fluid refilling (Refer to GROUP 23A - On-vehicle Service, CVT Fluid Change). <CVT>
  • Transmission fluid refilling (Refer to GROUP 22A - On-vehicle Service, Transmission Oil Change). <M/T>
  • Front under cover installation (Refer to GROUP 51 - Under Cover).
  • Check the beam direction of the headlamp (low beam) (Refer to GROUP 54A - Headlamp, On-vehicle Service, Headlamp Aiming ).




Driveshaft removal steps
<<A>>
 >>C<<
 1.
 Driveshaft nut


2.
 Front wheel speed sensor (Refer to GROUP 35B - Wheel speed sensor)


3.
 Front wheel speed sensor harness clamp


4.
 Brake hose clip

>>B<<
 5.
 Brake hose grommet
<<B>>
6.
 Self-locking nut (tie rod end connection)
<<B>>
7.
 Self-locking nut (lower arm ball joint connection)
<<C>>
 >>A<<
 8.
 Driveshaft assembly


9.
 Driveshaft


10.
 Circlip



Cover and heat protector removal steps


11.
 Front axle crossmember cover <CVT>


12.
 Front axle shaft heat protector