![](../../../img/35/ACE00541AC00ENG.png)
|
1.Connect two pressure
gauges to the output port of the master cylinder and output
port
of the proportioning valve. Tightening torque:
16 ± 3 N·m 2.Bleed the brake
line and the pressure gauges (Refer to ).
|
![](../../../img/35/AC006222AE00ENG.png)
|
3.Depress the brake pedal
gradually. Then check that the split point, where the output
fluid
pressure begins to drop in proportion to the output fluid
pressure, is at the standard value. Standard
value: 2.25 - 2.65 MPa 4.Depress the
brake pedal more strongly than at the above step. Then check
that the
output fluid pressure is at the standard value when the
input fluid pressure is 6.37 MPa. Standard
value: 2.34 - 3.14 MPa 5.Measure
each output fluid pressure at both valves, and check that
the difference between
the two is at the limit value or less. Limit:
0.4 MPa 6.If the measured pressure exceeds
the limit, replace the proportioning valve.
|