Code No. U1011:
FCM-LS Parity/Toggle bit error
caution |
- If there is any
problem in the CAN bus lines, an incorrect diagnosis code may be set. Prior to this diagnosis,
diagnose the CAN bus lines (Refer to GROUP 54C -
CAN Bus Diagnostics Table
).
- Whenever ECU is replaced, ensure that the CAN bus lines are normal.
- When the hydraulic unit (integrated with ASC-ECU) is replaced, always carry out
the calibration of the G and yaw rate sensor and the steering wheel sensor (Refer to
and ).
|
OPERATION
FCM-LS related signals are sent or received to and from between ASC-ECU and FCM-ECU via
CAN bus lines.
DIAGNOSIS CODE SET CONDITIONS
This diagnosis code is set when the ASC-ECU has detected an abnormal FCM-LS related signal.
PROBABLE CAUSES
- Malfunction of the FCM-ECU
- Malfunction of the hydraulic unit assembly (integrated with ASC-ECU)
- External noise interference
|
STEP 1. M.U.T.-III CAN bus diagnosis.
|
|
Use the M.U.T.-III to diagnose the CAN bus lines.
|
|
Q.
Is the check result normal?
|
|
Go to Step 3.
|
|
|
|
Repair the CAN bus line. (Refer to GROUP 54C -
Troubleshooting ).
On completion, go to Step 2.
|
|
|
|
STEP 2. Diagnosis code recheck after resetting CAN bus lines.
|
|
Q.
Is diagnosis code No. U1011 set?
|
|
Go to Step 3.
|
|
|
|
This diagnosis is complete.
|
|
|
|
STEP 3. Use M.U.T.-III to confirm a diagnosis code of other systems.
|
|
Check that the FCM-ECU diagnosis code(s) other than No. C1798 is set.
|
|
Q.
Is the diagnosis code set?
|
|
Follow the relevant diagnosis code procedure. (Refer to GROUP 54A -
Forward
Collision Mitigation System (Low speed range) (FCM-LS), Troubleshooting, Diagnosis Code Chart ).
Then go to Step 5.
|
|
|
|
Go to Step 4.
|
|
|
|
STEP 4. Check whether the diagnosis code is set again.
|
|
Check again if the diagnosis code is set.
|
|
(1)Erase the set diagnosis code.
|
|
(2)Ignition switch: "LOCK" (OFF)
|
|
Q.
Is diagnosis code No. U1011 set?
|
|
Replace the hydraulic unit assembly (integrated with ASC-ECU) (Refer to ). Then
go to Step 5.
|
|
|
|
The trouble can be an intermittent malfunction (Refer to GROUP 00 -
How
to Cope with Intermittent Malfunction).
|
|
|
|
STEP 5. Check whether the diagnosis code is set again.
|
|
Check again if the diagnosis code is set.
|
|
(1)Erase the set diagnosis code.
|
|
(2)Ignition switch: "LOCK" (OFF)
|
|
Q.
Is diagnosis code No. U1011 set?
|
|
Return to Step 3.
|
|
|
|
This diagnosis is complete.
|
|
|