REMOVAL AND INSTALLATION



Pre-removal Operation
  • Floor Console Removal (Refer to GROUP 52A - Floor Console Assembly ).
  • Rear Scuff Plate Removal (Refer to GROUP 52A - Trim ).
  • Heat Protector Panel Rear Removal (Refer to GROUP 15 - Exhaust Pipe and Main Maffler ).
  • Shoe and Lining Assembly Removal (Refer to GROUP 35A - Rear Drum Brake ).
  • Release the parking brake lever
  • Loosen the self-locking nut

Post-installation Operation
  • Shoe and Lining Assembly Installation (Refer to GROUP 35A - Rear Drum Brake ).
  • Heat Protector Panel Rear Installation (Refer to GROUP 15 - Exhaust Pipe and Main Maffler ).
  • Rear Scuff Plate Installation (Refer to GROUP 52A - Trim ).
  • Floor Console Installation (Refer to GROUP 52A - Floor Console Assembly ).
  • Parking Brake Lever Stroke Adjustment (Refer to ).





Removal steps

>>B<<
1.
Parking brake rear cable and parking lever connection

>>A<<
2.
Clamp


3.
Parking brake rear cable and backing plate connection


4.
Rear parking brake cable

INSTALLATION SERVICE POINTS



>>A<< CLAMP INSTALLATION



Install as marking of parking cable to be shown position.

>>B<< PARKING BRAKE REAR CABLE INSTALLATION


caution Check that the equalizer and the rear parking brake cable are connected correctly. If the parking brake is applied with the equaliser and the rear parking brake cable connected improperly, the equaliser may be damaged.

Connect the rear parking brake cable to the equaliser as shown in the figure.