Code No. U0126:
SAS CAN Timeout
caution |
- If there is any
problem in the CAN bus lines, an incorrect diagnosis code may be set. Prior to this diagnosis,
diagnose the CAN bus lines (Refer to GROUP 54C - CAN Bus Diagnostics Table
).
- Whenever ECU is replaced, ensure that the CAN bus lines are normal.
|
OPERATION
The EPS-ECU communicates with the steering wheel sensor via the CAN bus lines.
DIAGNOSIS CODE SET CONDITIONS
If the EPS-ECU cannot receive any signal from the steering wheel sensor for a predetermined
period, this diagnosis code will be set.
PROBABLE CAUSES
- The CAN bus line is defective
- Malfunction of the steering wheel sensor
- Malfunction of the EPS-ECU
|
STEP 1. M.U.T.-III CAN bus diagnosis.
|
|
Use the M.U.T.-III to diagnose the CAN bus lines.
|
|
Q.
Is the check result normal?
|
|
Go to Step 3.
|
|
|
|
Repair the CAN bus line. (Refer to GROUP 54C - Troubleshooting ).
On completion, go to Step 2.
|
|
|
|
STEP 2. Diagnosis code recheck after resetting CAN bus lines.
|
|
(1)Erase the diagnosis code.
|
|
(2)Turn the ignition switch from the "LOCK" (OFF) position to the "ON" position.
|
|
(3)Check if the diagnosis code is set.
|
|
Q.
Is diagnosis code No. U0126 set?
|
|
Go to Step 3.
|
|
|
|
This diagnosis is complete.
|
|
|
|
STEP 3. Check other diagnosis codes.
|
|
Check if diagnosis code(s) other than U0126 is set.
|
|
Q.
Is the diagnosis code set?
|
|
Perform troubleshooting for the relevant diagnosis code. (Refer to ).
Then go to Step 6.
|
|
|
|
Go to Step 4.
|
|
|
|
STEP 4. Use M.U.T.-III to confirm a diagnosis code of other systems.
|
|
Check whether a steering wheel sensor "time-out" related diagnosis code is set in other
ECUs.
|
|
Q.
Is the diagnosis code set?
|
|
Replace the steering wheel sensor. (Refer to GROUP 35C - Steering Wheel
Sensor ). Then go to Step 6.
|
|
|
|
Go to Step 5.
|
|
|
|
STEP 5. Check whether the diagnosis code is set again.
|
|
Check again if the diagnosis code is set.
|
|
(1)Erase the diagnosis code.
|
|
(2)Turn the ignition switch from the "LOCK" (OFF) position to the "ON" position.
|
|
(3)Check if the diagnosis code is set.
|
|
Q.
Is diagnosis code No. U0126 set?
|
|
Replace the EPS-ECU. Then go to Step 6.
|
|
|
|
The trouble can be an intermittent malfunction (Refer to GROUP 00 - How
to Cope with Intermittent Malfunction).
|
|
|
|
STEP 6. Check whether the diagnosis code is set again.
|
|
Check again if the diagnosis code is set.
|
|
(1)Erase the diagnosis code.
|
|
(2)Turn the ignition switch from the "LOCK" (OFF) position to the "ON" position.
|
|
(3)Check if the diagnosis code is set.
|
|
Q.
Is diagnosis code No. U0126 set?
|
|
Return to Step 1.
|
|
|
|
This diagnosis is complete.
|
|
|