REMOVAL AND INSTALLATION


Pre-removal operation
  • Door trim assembly removal (Refer to GROUP 52A - Door trim .)
  • Waterproof film removal (Refer to .)

 Post-installation operation
  • Door window glass adjustment (Refer to .)
  • Waterproof film installation (Refer to .)
  • Door trim assembly installation (Refer to GROUP 52A - Door trim .)
  • Learning procedures of the power window fully closed position <Vehicles with safety system> (Refer to .)




Door window glass assembly removal
<<A>>
1.
 Door window glass assembly



Power window regulator removal steps


·
 Door window rear lower sash (Refer to .)


·
 Door window glass runchannel (Refer to .)
<<A>>
2.
 Power window regulator assembly


3.
 Power window regulator motor
note For removal and installation of the power window switch, refer to GROUP 52A, Door trim .




Door window glass assembly removal steps


·
 Door window rear lower sash (Refer to .)


·
 Door window glass runchannel (Refer to .)
<<A>>
1.
 Door window glass assembly



Power window regulator removal steps
<<A>>
2.
 Power window regulator assembly


3.
 Power window regulator motor



Manual window regulator removal steps
<<B>>
 >>A<<
 4.
 Clip

>>A<<
 5.
 Regulator handle

>>A<<
 6.
 Escutcheon
<<A>>
7.
 Manual window regulator assembly
note For removal and installation of the power window switch, refer to GROUP 52A, Door trim .

REMOVAL SERVICE POINT

<<A>> DOOR WINDOW GLASS ASSEMBLY/ POWER WINDOW REGULATOR ASSEMBLY/ MANUAL WINDOW REGULATOR ASSEMBLY REMOVAL
1.Remove the door window glass mounting bolts.

caution If any film or the like is applied to a door window glass, use the window glass holder (Special tool: MB990480) at the outside of the door glass to prevent the film from peeling off.
2.Lift the door window glass, and attach the special tool MB990480 to the glass as shown to prevent the glass from falling.
3.Remove the power window regulator assembly.

<<B>> CLIP REMOVAL

Use cloth to remove the clip as shown in the illustration.

INSTALLATION SERVICE POINT

>>A<< RESCUTCHEON/REGULATOR HANDLE/CLIP INSTALLATION

1.Install escutcheon and regulator handle to the clip.
2.Close the door window glass fully, and then install the regulator handle as shown in the illustration.