DISASSEMBLY AND REASSEMBLY


Post-installation operationOperation check of the keyless operation key




Disassembly steps
<<A>>
1.
 Emergency key
<<B>>
2.
 Upper cover
<<B>>
3.
 Transmitter assembly
<<B>>
 >>A<<
 4.
 Battery
<<B>>
5.
 Lower cover

DISASSEMBLY SERVICE POINTS

<<A>> EMERGENCY KEY REMOVAL

Move the lever on the lower cover to the direction shown by the arrow to remove the emergency key from the keyless operation key.

<<B>> UPPER COVER/TRANSMITTER ASSEMBLY/BATTERY/LOWER COVER REMOVAL
caution Do not allow water or dust to enter the inside of the transmitter assembly when it is open. Also, do not touch the precision electronic device.

Set a flat-tipped screwdriver wrapped with protective tape as shown in the figure, and pry off the keyless operation key.

REASSEMBLY SERVICE POINT

>>A<< BATTERY INSTALLATION
caution Do not allow water or dust to enter the inside of the transmitter assembly when it is open. Also, do not touch the precision electronic device.

Install a battery with the positive side facing toward the lower cover.
Replacement battery: Coin-type lithium battery CR2032