![](../../../img/51/ACB03341AD00ENG.png)
|
The windshield wiper motor
assembly should be installed to the vehicle body and the
harness
connector should be disconnected when checking the wiper
motor.
|
|
Connect the battery to the
windshield wiper motor to inspect the operation of motor
rotation
at low or high speed.
|
![](../../../img/51/ACC04654AB00ENG.png)
![](../../../img/51/ACB04366AD00ENG.png)
|
1.Connect the battery to the
windshield wiper motor as shown in the illustration
(A). 2.Run the windshield wiper motor at low
speed, then disconnect the battery in the middle
of the motor rotation and check to see that the motor
stops. 3.Connect the battery to the windshield
wiper motor as shown in the illustration
(B). 4.Connect the terminals of the windshield
wiper motor connector as shown in the illustration
(B). 5.Check to see that the windshield wiper
motor runs at low speed and then stops at the
automatic stop position.
|
|
Check the windshield wiper switch
(mist, intermittent, low speed and high speed) from
the ETACS diagnosis codes for proper operations (Refer to
GROUP 54A, ETACS ).
|