Inspection Procedure 1: Electric-folding door mirrors do not work at all.


caution Whenever the ECU is replaced, ensure that the input and output signal circuits are normal.

OPERATION


The ETACS-ECU operates this function in accordance with the input signals below.

COMMENTS ON TROUBLE SYMPTOM


If the system does not work, the input circuit from the Ignition switch (ACC), the remote controlled mirror switch (fold switch), or the ETACS-ECU may be defective.

PROBABLE CAUSES



DIAGNOSIS PROCEDURE

STEP 1. M.U.T.-III diagnosis code.
Check if an ETACS-related diagnosis code is set.

Q. Is the diagnosis code set?
Diagnose the ETACS (Refer to GROUP 54A - ETACS, Diagnosis Code Chart ).
Go to Step 2.

STEP 2. M.U.T.-III data list
Check the input signals which are related to the electric-folding door mirrors.

  • Ignition switch: ACC
  • Remote controlled door mirror switch (fold switch): ON
Item No.
 Item name
 Normal condition
Item 22
 Electric folding door mirror SW
 ON
Item 29
 Ignition switch (ACC)
 ON
OK: Normal conditions are displayed for all the items.

Q. Is the check result normal?
Normal conditions are displayed for all the items. : Go to Step 3.
Normal condition is not displayed for item No. 22. : Refer to GROUP 54A - ETACS, Inspection Procedure 11 "The remote controlled mirror switch signal is not received" .
Normal condition is not displayed for item No. 29. : Refer to GROUP 54A - ETACS, Inspection Procedure 1 "The ignition switch (ACC) signal is not received" .

STEP 3. M.U.T.-III data list
Check the data list which are related to the electric-folding door mirrors.

  • Turn on the remote controlled door mirror switch (fold switch) when the door mirrors are folded.
Item No.
 Item name
 Normal condition
Item 88
 ELC.folding mirror (OPEN) output
 ON
Item 89
 ELC.folding mirror (CLOSE) output
 OFF

  • Turn on the remote controlled door mirror switch (fold switch) when the door mirrors are unfolded.
Item No.
 Item name
 Normal condition
Item 88
 ELC.folding mirror (OPEN) output
 OFF
Item 89
 ELC.folding mirror (CLOSE) output
 ON
OK: Normal condition is displayed.

Q. Is the check result normal?
Go to Step 5.
Go to Step 4.

STEP 4. Check of short to power supply, short to earth, and open circuit in D/LOCK line between fusible link and ETACS-ECU connector

Q. Is the check result normal?
Go to Step 5.
Repair the connector(s) or wiring harness.

STEP 5. Check the trouble symptom.
Check that the electric-folding door mirrors work normally.

Q. Is the check result normal?
Intermittent malfunction (Refer to GROUP 00 - How to Use Troubleshooting/Inspection Service Points, - How to Cope with Intermittent Malfunctions ).
Replace the ETACS-ECU.