|
These conditions must be corrected
before a satisfactory adjustment can be made.
|
|
- Inspect tyre inflation, and adjust if it is
necessary.
- If the fuel tank is not filled up, put weight in the
luggage compartment to make
up for the fuel shortage so that the weight will
become 90%
of full-state weight or
heavier. (0.8 kg per litter)
- There should be no other load in the vehicle other
than driver or substituted weight
of approximately 75 kg placed in driver’s
position.
- Turn the headlamp levelling switch to the switch
position "0."
- Thoroughly clean the headlamp lenses.
|
![](../../../img/54/AC102583AA00ENG.png)
|
1.The headlamps should be
aimed with the proper beam setting equipment, and in
accordance
with the equipment manufacture’s
instructions. 2.Alternately turn the adjusting
screw to adjust the headlamp aiming.
|
![](../../../img/54/AC505906AB00ENG.png)
![](../../../img/54/ACB03043AB00ENG.png)
|
1.Place the vehicle on a
level floor, perpendicular to a flat screen 3 m away from
the bulb
centre position of the low-beam. 2.Rock vehicle
sideways to allow vehicle to assume its normal
position. 3.To correct for distortion of the
suspension, rock the bumpers on the front/rear
side of the vehicle up and down three times
alternately. 4.Run the engine at a speed of 2,000
r/min to charge the battery. 5.Four lines of
adhesive tape (or equivalent markings) are required on
screen or wall: (1)
Position a vertical tape or mark so that it is aligned with
the vehicle centre line. (2)
Measure the distance from the bulb centre position to the
floor. Transfer the measurement
to the screen. Horizontal tape or mark on the screen is for
reference of vertical adjustment. (3)
Measure the distance from the centre line of the vehicle to
the centre of each headlamp.
Transfer the measurement to the screen. Vertical tape or
mark on the screen with reference to
the centre line of each headlamp bulb.
|
![](../../../img/54/ACB03502AB00ENG.png)
|
- The low-beam headlamp should project on the screen
upper
edge of the beam (cut-off).
- If not the case, turn the adjusting screws to
achieve the specified low-beam cut-off location
on the aiming screen.
|
![](../../../img/54/ACB03501AB00ENG.png)
|
Standard
value: Vertical direction;
36 mm (0.69°) below horizontal (H) Horizontal
direction;
Elbow point intersects the vertical line
(V) Limit: Vertical direction;
±15 mm (±0.29°) from the horizontal
cut-off
line Horizontal direction;
±
26 mm (±0.5°) from the vertical line
(V)
|