Code No.U1190
No receive fault detect signal
JUDGEMENT CRITERIA
ETACS-ECU sends the diagnosis code (U code) detection permission or prohibition signal
to each ECU connected to the CAN bus line. If the combination meter cannot receive the diagnosis code
(U code) detection permission or prohibition signal for 5 seconds after turning the electric
motor switch to ON position, diagnosis code U1190 will be set.
PROBABLE CAUSES
- Malfunction of the ETACS-ECU
- Malfunction of CAN bus line
DIAGNOSIS PROCEDURE
STEP 1. M.U.T.-III CAN bus diagnostics
Use the M.U.T.-III to diagnose the CAN bus lines.
Q.
Is the check result normal?
Go to Step 2
Repair the CAN bus line (Refer to GROUP 54C -
Troubleshooting 
).
On completion, go to Step 3.
STEP 2. Check whether the diagnosis code is reset.
Check again if the diagnosis code is set to the combination meter.
|
|
(1)Erase the diagnosis code.
|
|
|
(2)Turn the ignition motor switch from "LOCK" (OFF) position to "ON" position.
|
|
|
(3)On completion, check that the diagnosis code is reset.
|
Q.
Is the diagnosis code set?
Replace the ETACS-ECU. Then go to Step 3.
The procedure is complete.
STEP 3. Check whether the diagnosis code is reset.
Recheck if the diagnosis code is set to the combination meter.
|
|
(1)Erase the diagnosis code.
|
|
|
(2)Turn the ignition motor switch from "LOCK" (OFF) position to "ON" position.
|
|
|
(3)On completion, check that the diagnosis code is reset.
|
Q.
Is the diagnosis code set?
Return to Step 1.
The procedure is complete.