![](../../../img/54/AC804645AB00ENG.png)
![](../../../img/54/ACF03413AB00ENG.png)
|
1.Measure the centre of the
front fog lamps, as shown in the
illustration. 2.Set the distance between the
screen and the centre of the front fog lamps as shown
in the illustration. 3.Inflate the types to the
specified pressures and there should be no other load in
the vehicles other than driver or substituted weight of
approximately 75 kg placed in the driver’s
position. 4.With the engine running at 2,000
r/min, aim the front fog lamp. 5.Insert a
Phillips screwdriver into the service hole and place it on
the adjusting
screw.
|
![](../../../img/54/ACF03414AD00ENG.png)
![](../../../img/54/ACC03310AC00ENG.png)
![](../../../img/54/AC312871AB00ENG.png)
|
6.Adjust the cut off line
(boundary between light and dark) position to the standard
value
with the adjusting screw. Standard
value: Vertical direction; 60 mm (1.15°) below
horizontal (H) Limit: Vertical
direction; 45 mm (0.86°) to 100 mm (1.9°)
below the horizontal
(H)
note |
The horizontal direction is
non-adjustable.
|
|