Inspection Procedure
3: The front fog lamp indicator does not illuminate normally.
caution
Whenever the ECU is replaced, ensure that the
power supply circuit, the earth circuit and the communication circuit are normal.
COMMENTS ON TROUBLE SYMPTOM
If the front fog lamp indicator does not illuminate normally, connector(s), wiring harness
in the CAN bus lines, the ETACS-ECU or the combination meter may be defective.
PROBABLE CAUSES
Malfunction of the ETACS-ECU
Malfunction of the combination meter
Damaged harness wires and connectors
DIAGNOSIS PROCEDURE
STEP 1. Check the front fog lamps
When the front fog lamp switch is operated, check that the front fog lamps illuminate/go
off normally.
Q.
Is the check result normal?
Go to Step 2.
First, repair the front fog lamps (Refer to trouble symptom chart ).
STEP 2. M.U.T.-III CAN bus diagnostics
Use the M.U.T.-III to diagnose the CAN bus lines.
Q.
Is the check result normal?
Go to Step 3.
Repair the CAN bus line (Refer to GROUP 54C -
Troubleshooting ).
STEP 3. M.U.T.-III diagnosis code
Check if diagnosis code is set to the ETACS-ECU.
Q.
Is the diagnosis code set?
Troubleshoot the ETACS-ECU. Refer to .
Go to Step 4.
STEP 4. M.U.T.-III other system actuator test
Perform the actuator test for the combination meter, and check that the front fog lamp
indicator illuminates (Refer to Combination Meter ).