Inspection Procedure
15: The back-up lamp switch signal is not received. <M/T>
caution |
Whenever the ECU is replaced,
ensure that the input signal circuit is normal.
|
COMMENTS ON TROUBLE SYMPTOM
Input signal from the back-up lamp switch is used to operate the Hill Start Assist (HSA)
system functions below. If the signal is abnormal, these functions will not work normally.
PROBABLE CAUSES
- Malfunction of the back-up lamp switch
- Malfunction of the ETACS-ECU
- Damaged harness wires and connectors
|
STEP 1. Check the operation of the back-up lamps.
|
|
Check that the back-up lamps illuminate normally.
|
|
Q.
Is the check result normal?
|
|
Go to Step 2.
|
|
|
|
Diagnose the rear combination lamps (Refer to ).
Then go to Step 5.
|
|
|
|
STEP 2. Voltage measurement at ETACS-ECU connector (BACK-UP LAMP terminal).
|
|
(1)Disconnect the connector, and measure at the wiring harness side.
|
|
(2)Turn the ignition switch to the "ACC" position.
|
|
(3)Check the voltage between the ETACS-ECU connector (BACK-UP LAMP terminal) and body earth. OK:
When the shift lever is at the reverse position: Approx. system voltage When the shift lever is at other than the reverse position: 1V or less
|
|
Q.
Is the check result normal?
|
|
Go to Step 3.
|
|
|
|
The power supply circuit may be open or short. Repair the connectors or the wiring
harness wires between the ETACS-ECU connector and the back-up lamp switch connector. Then go
to Step 5.
|
|
|
|
STEP 3. Use M.U.T.-III to confirm a diagnosis code of other system.
|
|
Check if the diagnosis code is set in the ASC-ECU.
|
|
Q.
Is the diagnosis code set?
|
|
Troubleshoot the ASC-ECU diagnosis code (Refer to GROUP 35C - Diagnosis
Code Chart ). Then go to Step 5.
|
|
|
|
Go to Step 4.
|
|
|
|
STEP 4. Retest the system.
|
|
Check if the HSA works with one person on the driver’s seat.
|
|
Q.
Is the check result normal?
|
|
The trouble can be an intermittent malfunction.
|
|
|
|
Replace the ETACS-ECU. Then go to Step 5.
|
|
|
|
STEP 5. Retest the system.
|
|
Check if the HSA works with one person on the driver’s seat.
|
|
Q.
Is the check result normal?
|
|
This diagnosis is complete.
|
|
|
|
Return to Step 2.
|
|
|