Diagnosis Item
15: Diagnose when the M.U.T.-III cannot receive the data sent by FCM-ECU. <Vehicles with
FCM-LS>
caution |
When servicing a CAN bus line,
earth yourself by touching a metal object such as an unpainted water pipe. If you fail to do,
a component connected to the CAN bus line may be broken.
|
FUNCTION
The diagnostic result demonstrates that "the M.U.T.-III cannot receive the sent data from
the FCM-ECU" when the M.U.T.-III checks the periodically sent data from each ECU and cannot
receive the FCM-ECU data only.
TROUBLE JUDGEMENT CONDITIONS
M.U.T.-III judges the trouble when the periodically sent data from FCM-ECU cannot be received.
PROBABLE CAUSES
- Damaged harness wires and connectors
- Power supply circuit malfunction of the FCM-ECU
- Malfunction of the FCM-ECU
|
STEP 1. Connector check: joint connector (CAN1) and FCM-ECU
connector
|
|
caution |
The strand end of the twist wire should be within 10 cm from
the connector.
|
|
|
When checking the joint connector, ensure that its wiring harness side and its short pins
are not damaged.
|
|
Q.
Is the check result normal?
|
|
Go to Step 2.
|
|
|
|
Repair the defective connector. Replace the joint connector as necessary.
|
|
|
|
STEP 2. Resistance measurement at joint connector (CAN1) and FCM-ECU
connector.
|
|
caution |
- A digital multimeter should
be used.
- The test wiring harness should be used.
- Strictly observe the specified wiring harness repair procedure.
|
|
|
(1)Disconnect joint connector (CAN1) and the FCM-ECU connector, and measure at the
wiring harness side.
|
|
(2)Turn the ignition switch to the LOCK (OFF) position.
|
|
(3)
caution |
When measuring the resistance, disconnect the negative battery
terminal.
|
Ensure that the negative battery terminal is disconnected.
|
|
(4)Continuity between joint connector (CAN1) terminal No.5 and FCM-ECU connector terminal
No.4. OK: Continuity (2 Ω or less)
|
|
(5)Continuity between joint connector (CAN1) terminal No.16 and FCM-ECU connector
terminal No.5. OK: Continuity (2 Ω or less)
|
|
Q.
Is the check result normal?
|
|
<All the resistances measure 2 Ω or less> Power supply
to the FCM-ECU may be suspected. Diagnose the FCM-ECU. (Refer to GROUP 54A - FCM-LS, Inspection
Procedure 1 ).
|
|
|
|
NO : <Either or all of the resistances measure more than 2 Ω> Repair
the wiring harness between joint connector (CAN1) and the FCM-ECU connector.
|
|
|