Diagnosis Item
16: Diagnose when the M.U.T.-III cannot receive the data sent by ASC-ECU.
caution |
When servicing a CAN bus line,
earth yourself by touching a metal object such as an unpainted water pipe. If you fail to do,
a component connected to the CAN bus line may be broken.
|
FUNCTION
The diagnostic result demonstrates that "the M.U.T.-III cannot receive the sent data from
the ASC-ECU" when the M.U.T.-III checks the periodically sent data from each ECU and cannot
receive the ASC-ECU data only.
TROUBLE JUDGEMENT CONDITIONS
M.U.T.-III judges the trouble when the periodically sent data from ASC-ECU cannot be received.
PROBABLE CAUSES
- Damaged harness wires and connectors
- Power supply circuit malfunction of the ASC-ECU
- Malfunction of the ASC-ECU
|
STEP 1. Connector check: joint connector (CAN2) and ASC-ECU
connector.
|
|
caution |
The strand end of the twist wire should be within 10 cm from
the connector. For details refer to service precautions.
|
|
|
When checking the joint connector, ensure that its wiring harness side and its short pins
are not damaged.
|
|
Q.
Is the check result normal?
|
|
Go to Step 2.
|
|
|
|
Repair the defective connector. Replace the joint connector as necessary.
|
|
|
|
STEP 2. Resistance measurement at joint connector (CAN2) and ASC-ECU
connector.
|
|
caution |
- A digital multimeter should
be used. For details refer to service precautions.
- The test wiring harness should be used. For details refer to service precautions.
- Strictly observe the specified wiring harness repair procedure. For details refer
to service precautions.
|
|
|
(1)Disconnect joint connector (CAN2) and the ASC-ECU, and measure at the wiring harness
side.
|
|
(2)Turn the ignition switch to the "LOCK" (OFF) position.
|
|
(3)
caution |
When measuring the resistance, disconnect the negative battery
terminal. For details refer to service precautions.
|
Ensure that the negative battery terminal is disconnected.
|
|
(4)Continuity between joint connector (CAN2) terminal No. 9 and ASC-ECU connector
terminal No. 26. OK: Continuity (2 Ω
or less)
|
|
(5)Continuity between joint connector (CAN2) terminal No. 20 and ASC-ECU connector
terminal No. 14. OK: Continuity (2 Ω
or less)
|
|
Q.
Is the check result normal?
|
|
<All the resistances measure 2 Ω
or less>
Power supply
to the ASC-ECU may be suspected. Diagnose the ASC-ECU. Refer to GROUP 35C -
Troubleshooting,
Inspection Procedure 11 .
|
|
|
|
NO : <Either or all of the resistances measure more than 2 Ω>
Repair
the wiring harness between joint connector (CAN2) and the ASC-ECU connector.
|
|
|