DAMPER CONTROL MOTOR ASSEMBLY REMOVAL AND INSTALLATION



Outside/inside air selection damper control motor and potentiometer removal step


·
 Passenger’s (front) air bag module (Refer to GROUP 52B, Passenger’s (front) air bag module )
<<A>>
1.
 Outside/Inside air selection damper control motor and potentiometer




Mode selection damper control motor and potentiometer removal step


·
 Instrument panel lower cover (Refer to GROUP 52A, Instrument panel lower cover )


2.
 Mode selection damper control motor and potentiometer



Air mixing damper control motor and potentiometer removal step
<<B>>
3.
 Air mixing damper control motor and potentiometer

REMOVAL SERVICE POINT

<<A>> OUTSIDE/INSIDE AIR SELECTION DAMPER CONTROL MOTOR AND POTENTIOMETER REMOVAL <RHD>

1.Cut down the projection on the heater case along the head of the mounting screw as shown.
2.Use a commercial plate type ratchet screwdriver and a wrench to remove the outside/inside air selection damper control motor and potentiometer.

note A commercial plate type ratchet screwdriver is recommended.

<<B>> AIR MIXING DAMPER CONTROL MOTOR AND POTENTIOMETER REMOVAL

note A commercial plate type ratchet screwdriver is recommended.