|
1.Remove the A/C
compressor and clutch assembly together with the hose from
the bracket.
|
|
2.Tie the removed A/C
compressor and clutch assembly with a string at a position
where they will not interfere with the removal and
installation of engine oil pan.
|
|
1.Remove the engine oil pan
mounting bolts.
|
|
2.
caution |
Do not forcibly drive in
special tool oil pan FIPG cutter (MD998727)
to avoid damage to the engine oil pan seal
surface of cylinder block assembly.
|
Insert special tool oil pan FIPG cutter (MD998727)
from the engine oil pan removal groove
of the cylinder block assembly. 3.Lightly tap the
special tool (MD998727) with a hammer to slide the engine
oil pan
seal surface, cut off the liquid gasket, and remove the
engine oil pan.
|
|
1.Remove all the traces of
sealant adhering to the engine oil pan and cylinder block
assembly using a remover or others. Then, degrease
them.
|
|
2.Apply the sealant without
any gap to the mating surface of engine oil pan as shown in
the figure, and install the engine oil pan to the cylinder
block assembly. Specified sealant: ThreeBond
1217G or equivalent
note |
Install the engine oil pan
immediately after applying sealant.
|
3.
caution |
After the installation, until
a sufficient period of time (one hour or
more) elapses, do not apply the oil or water to
the sealant application area or start the
engine.
|
Tighten the engine oil pan mounting bolts to the
specified torque. Tightening torque:
M6: 10 ±
2 N·m M8: 29 ±
2 N·m
|
|
Tighten A/C compressor and
clutch assembly mounting bolts to the specified torque
in the order of number shown in the
illustration. Tightening torque: 23 ±
6 N·m
|