![](../../../img/11/AC506761AC00ENG.png)
|
Fix the drive plate using the
flywheel stopper (Special Tool: MB991883),
and loosen the drive plate bolts.
|
|
1.Apply a small amount of
engine oil to the entire inner diameter of the oil seal
lip.
|
![](../../../img/11/AC506762AB00ENG.png)
|
2.Using the crankshaft rear
oil seal installer (Special tool: MD998718), press in the
crankshaft
rear oil seal up to the cylinder block assembly end
surface.
|
|
1.Remove the engine oil and
deposits from the drive plate bolt threads, crankshaft
tapped
hole, and drive plate.
|
|
2.Install the drive plate
and drive plate adapter plate to the crankshaft.
|
![](../../../img/11/AC506761AC00ENG.png)
|
3.In the same way as with
removal, fix the drive plate using a flywheel stopper
(Special
tool: MB991883).
|
![](../../../img/11/AC609795AC00ENG.png)
|
4.Apply a small amount of
engine oil to the drive plate bolt bearing surface, and
apply
the sealant to the drive plate bolt
threads. Specified sealant: ThreeBond 1324 or
equivalent
|
![](../../../img/11/AC609796AC00ENG.png)
|
5.Tighten the drive plate
bolt to the specified torque 40 N·m in the order of
the
number shown in the figure. 6.After tightening to
the specified torque, tighten the drive plate bolt again to
the
specified torque 130 N·m in the order of the number
shown in the figure.
|
|
1.Apply a small amount of
engine oil to the entire inner diameter of the oil seal
lip.
|
![](../../../img/11/AC506763AB00ENG.png)
|
2.
caution |
When installing the crankshaft
oil seal, be careful to
avoid damage to the crankshaft front oil
seal.
|
Using a bush remover and installer base (Special
tool: MB991448), press in the crankshaft
front oil seal up to the chamfered surface of timing chain
case.
|