![](../../../img/11/AK502869AC00ENG.png)
|
1.Use special tool Flywheel
stopper (MB991883) to secure the drive
plate. 2.Remove the crankshaft pulley centre
bolt.
|
![](../../../img/11/AK600875AB00ENG.png)
|
Using special tool Spark plug
wrench (MB991398), remove the spark plug.
|
![](../../../img/11/AK600875AB00ENG.png)
|
Use special tool Spark plug wrench
(MB991398), tighten the spark plug
to specified torque of 25 ± 5 N·m.
|
![](../../../img/11/AK503335AC00ENG.png)
|
1.Use special tool Flywheel
stopper (MB991883) to secure the drive plate
or flywheel.
|
![](../../../img/11/AC606441AD00ENG.png)
|
2.Wipe off the dirt on the
crankshaft pulley washer and on the thread hole
of the crankshaft using a rag. 3.Wipe off the dirt
on the crankshaft pulley and the crankshaft sprocket
using a rag, and then remove the grease from the portion
shown in the illustration.
note |
Remove grease to prevent the
coefficient of friction of the pressing portion
from declining
due to adhesion of oil.
|
4.Install the crankshaft
pulley. 5.Apply an appropriate and minimum amount
of engine oil to the threaded
portion of the crankshaft and lower part of the
flange. 6.With the chamfered side on the inside of
the washer facing the bolt
top, install the crankshaft pulley washer to the crankshaft
pulley centre bolt. 7.Tighten the crankshaft
pulley centre bolt to the specified
torque. Tightening torque: 210
N·m 8.Loosen the crankshaft pulley
centre bolt fully. 9.Tighten the crankshaft pulley
centre bolt to the specified torque
again. Tightening torque: 210
N·m
|
![](../../../img/11/AKC00006AB00ENG.png)
|
1.Temporarily tighten
alternator bolt and nut. 2.First tighten the upper
mounting bolt to the specified torque, and then tighten the
lower nut. Specified torque: 44 ± 10
N·m
|