![](../../../img/11/ACA01323AB00ENG.png)
![](../../../img/11/ACA01361AB00ENG.png)
|
note |
Use the recommended tool
f/head & o/end combination
wrench
(MB992699) to remove the EGR valve mounting bolt
shown in the figure.
|
|
|
1.Insert the glow plug into
the cylinder head. Rotate them 2 or 3 times by hand to
temporarily
install them. Use the wrench and temporarily tighten
them.
|
|
2.To the specified torque of
18 ± 2 N·m, tighten the glow plug that
is temporarily tightened.
|
![](../../../img/11/AK802544AC00ENG.png)
|
1.Temporarily install the
EGR pipe "A" and the EGR pipe gasket to the EGR valve. Put
the
EGR pipe gasket tab to the position shown in the
illustration.
|
![](../../../img/11/AK802543AC00ENG.png)
|
2.Put the EGR valve gasket
tab to the position shown in the
illustration. 3.Install the temporarily tightened
EGR pipe A and the EGR valve to the cylinder head
and the EGR cooler. Check that there is no clearance among
each component. Temporarily tighten
the bolts, 1, 4 and 6, as shown in the
illustration. Temporary tightening torque: 1.3
± 0.7 N·m 4.To the specified
torque, tighten each bolt in the order shown in the
illustration. Specified torque: 20 ± 2
N·m
|
![](../../../img/11/AK802546AC00ENG.png)
|
Put the inlet manifold gasket tab
to the position shown in the illustration. Install the
inlet manifold gasket to the cylinder head.
|
|
1.Check the vacuum outlet
port for clogging, and clean it if necessary.
|
|
2.Temporarily install the
inlet manifold to the cylinder head.
|
![](../../../img/11/AK802554AC00ENG.png)
|
3.In accordance with the
order shown in the illustration, tighten the inlet manifold
bolts
and nuts to the specified torque of 20 ± 2
N·m.
|
![](../../../img/11/AK802547AC00ENG.png)
|
1.Put the EGR pipe gasket
tab to the position shown in the
illustration. 2.Install the temporarily tightened
EGR pipe B to the EGR valve and the inlet manifold.
Check that there is no clearance among each
component. Temporary tightening torque: 1.3
± 0.7 N·m 3.Install the
tightened EGR pipe B to the specified
torque. Specified torque: 20 ± 2
N·m
|
![](../../../img/11/AK802545AC00ENG.png)
|
Put the throttle body gasket tab to
the position shown in the illustration to install
the inlet manifold.
|