![](../../../img/11/AK600888AB00ENG.png)
|
caution |
- Do not allow sealant to
squeeze out to the screw tip.
- Do not tighten, exceeding the specified
torque.
|
1.Completely remove sealant adhering to the
oil pressure switch and cylinder block threaded
holes. 2.Apply sealant of 5 mm to the threaded
portion of the oil pressure switch shown in
the illustration. Specified
sealant:
ThreeBond 1212D, ThreeBond 1215
or equivalent
3.Tighten the oil
pressure switch to the cylinder block to the specified
torque of 10 ± 2
N·m.
|
![](../../../img/11/AC807670AD00ENG.png)
|
Align the detonation sensor
connector with the position shown in the illustration, and
then tighten it to the specified torque of 20 ± 2
N·m.
|
|
Install the inlet manifold and
temporarily tighten bolts.
|
![](../../../img/11/AK502727AC00ENG.png)
|
Make sure that the inlet manifold
stay is in intimate contact with the inlet manifold
and cylinder block boss before tightening it to the
specified torque of 20 ± 2 N·m.
|
![](../../../img/11/AK600790AB00ENG.png)
|
When inserting an O-ring into the
injector on the injection nozzle side, use special tool
O-ring installer (MB992106) to gradually expand the O-ring,
and fit it in place.
|
|
1.Apply gasoline to the
O-ring of the injector.
|
|
2.Insert the injector into
the delivery pipe while rotating the injector from side to
side, taking care not to damage the O-ring.
|
|
3.Check that the injector
rotates smoothly. If it does not rotate smoothly, the O-ring
may be caught. Remove the injector and check the O-ring for
damage. Then, insert it again into the
delivery pipe and check.
|
![](../../../img/11/AK502744AA00ENG.png)
|
4.Make sure that the
protrusion of the injector is at the centre as shown in the
illustration.
|
![](../../../img/11/AK800066AA00ENG.png)
|
5.Securely assemble the
injector to the injector groove and delivery pipe
collar.
|
![](../../../img/11/AK700818AC00ENG.png)
|
1.Install the delivery pipe
assembly, bracket and injector protector on the cylinder
head. 2.Tighten mounting bolts together with
temporarily tightened inlet manifold mounting
bolts in the order shown in the
illustration. 3.Tighten the delivery pipe
assembly, bracket, injector protector rear and inlet
manifold
in the order shown in the
illustration.
Temporarily
torque: 3.5 ± 1.5 N·m Specified
torque: 20 ± 2 N·m
|