|
|
1.Start the engine and allow
it to warm up until the temperature of the coolant reaches
80 °C to 90 °C.
|
|
|
2.
| warning |
Use care as oil could be
hot.
|
Remove the engine oil filler cap.
|
|
|
3.Remove the engine room
under cover front B (Refer to GROUP 51 -
Under Cover).
|
|
|
4.Remove the engine oil pan
drain plug to drain engine oil.
|
|
5.Use the respective tool in
the following table to remove the engine oil
filter.
|
|
Number
|
Special
tool
|
MD360935
|
Oil filter wrench
(MB991396) or equivalent
|
|
6.Clean the engine oil filter bracket side
mounting surface and ensure the old O-ring
has been removed.
|
|
7.Apply a small amount of
engine oil to the new O-ring of the new engine oil
filter.
8.Where the engine oil filter O-ring
touches the engine oil filter bracket flange, tighten
the engine oil filter to the specified torque using the
commercially-available tool.
|
|
Number
|
Special
tool
|
Tightening
torque
|
MD360935
|
Oil filter wrench
(MB991396) or equivalent
|
Approximately 1 turn
(14 ±
2 N·m)
|
|
9.Install the engine oil pan drain plug and
refill the engine oil (Refer to  ).
10.Rev
the engine a few times, and check to be sure that no engine
oil leaks from the
installation section of the engine oil
filter.
11.Install the engine room under cover
front B (Refer to GROUP 51 -
Under Cover).
|