|
When removing the fuel pipes and
fuel hoses, follow the procedure below to release fuel
pressure in the line and prevent fuel from running out,
because fuel pressure in the fuel line
is high.
|
|
1.Remove the second seat
assembly (Refer to GROUP 52A - Second Seat Assembly )
and turn up the floor carpet.
|
|
2.Remove the floor
inspection lid (LH).
|
|
3.Disconnect the fuel tank
pump and gauge assembly connector. 4.Crank the
engine for at least two seconds. 5.If the engine
does not start, turn the ignition switch to the "LOCK" (OFF)
position. 6.If the engine is started, turn the
ignition switch to the "LOCK" (OFF) position after
the engine stopped. 7.Connect the fuel tank pump
and gauge assembly connector. 8.Install the floor
inspection lid (LH). 9.Return the floor carpet to
the original condition and install the second seat assembly
(Refer to GROUP 52A - Second Seat Assembly ).
|