|
1.Remove the fuel tank
cap.
|
|
2.Using M.U.T.-III, forcibly
drive the fuel pump (integrated in the fuel pump and gauge
assembly) to check the fuel pump operation.
note |
The operating sound of the
fuel pump is difficult to be heard because the
pump is in-tank
type. Therefore, remove the fuel filler cap to
check the sound from the fuel filler
port.
|
|
|
3.If the fuel pump does not
operate, follow the procedure below to check the pump for
operation. If it is normal, check the driving
circuit. (1)
Turn the ignition switch to the "LOCK" (OFF)
position. (2)
Remove the second seat assembly (refer to GROUP 52A -
Second Seat Assembly )
and turn up the floor carpet. (3)
Remove the floor inspection lid (LH). (4)
Disconnect the fuel pump and gauge assembly
connector. (5)
When the battery is connected to the fuel pump and gauge
assembly connector terminals
No. 4 and 5 (fuel tank pump and gauge assembly side), check
that the pump operating sound can
be heard. When the pump operating sound cannot be heard,
replace the fuel pump (Refer to GROUP
13C- On-vehicle Service - Fuel Pump and Gauge
Assembly Replacement ).
|
note |
The operating
sound of the fuel pump is difficult
to be heard because the pump is
in-tank
type. Therefore, remove the fuel
filler cap to check the sound from
the fuel filler port.
|
|
(6)
Install the fuel tank cap. (7)
Connect the fuel pump and gauge assembly connector. (8)
Install the floor inspection lid (LH). (9)
Return the floor carpet to the original condition and
install the second seat assembly
(Refer to GROUP 52A - Second Seat Assembly ).
|