|
- Connect the M.U.T.-III to the diagnosis connector.
- When the power of Vehicle Communication Interface (V.C.I.) is turned to ON, the indicator lamp of the Vehicle Communication Interface (V.C.I.) illuminates in green.
|
|
OK: The indicator lamp of the Vehicle Communication Interface (V.C.I.) illuminates in green.
|
|
Q.
Is the check result normal?
|
|
- Check battery (Refer to GROUP 54A - Battery - On-vehicle Service - Battery Test ).
|
|
Q.
Is the check result normal?
|
|
- Voltage between terminal power supply line and body earth.
|
|
Q.
Is the check result normal?
|
|
- Check power supply line for open/short circuit.
|
|
Q.
Is the check result normal?
|
|
Repair or replace the connector, or repair the damaged harness wire.
|
|
|
|
- Check power supply line for open/short circuit.
|
|
Q.
Is the check result normal?
|
|
Check fuse in the ETACS-ECU, and replace if necessary. If the fuse is normal, replace the ETACS-ECU.
|
|
|
|
Repair or replace the connector, or repair the damaged harness wire.
|
|
|
|
- Resistance between terminals earth lines and body earth.
|
|
OK: Continuity (2 Ω or less)
|
|
Q.
Is the check result normal?
|
|
Check intermediate connector, and repair if necessary. If intermediate connector is normal, check and repair the harness between the diagnosis connector terminals earth lines and body earth.
- Check earthing line for open circuit and damage.
|
|
|
|
- Disconnect connectors, and measure at ETACS-ECU side.
- Continuity check between terminal +B1 and IG1.
|
|
Q.
Is the check result normal?
|
|
Repair or replace the connector, or check fuse in the ETACS-ECU, and replace if necessary. If the fuse is normal, replace the ETACS-ECU.
|
|
|
|
- Check power supply line for damage.
|
|
Q.
Is the check result normal?
|
|
Repair the damaged harness wire.
|
|
|
|
- Check power supply line for damage.
|
|
Q.
Is the check result normal?
|
|
Refer to the M.U.T.-III reference manual.
|
|
|
|
Repair the damaged harness wire.
|
|
|
|
- Use M.U.T.-III, perform CAN bus line diagnosis.
|
|
Q.
Is the check result normal?
|
|
Check Inspection Procedure - engine-ECU power supply, engine control relay, ignition switch-IG1 system (Refer to ).
|
|
|
|
Perform troubleshooting for CAN (Refer to GROUP 54C - Troubleshooting - CAN Bus Diagnostics Table ).
|
|
|