|
- Data list reference table (Refer to ).
|
|
- Item 2: Crank angle sensor
- Item 5: Intake air temperature sensor
- Item 6: Engine coolant temperature sensor
- Item 10: Air flow sensor
- Item 26: Long-term fuel trim
- Item 28: Short-term fuel trim
|
|
Q.
Are the check results normal?
|
|
Perform the diagnosis code classified check procedure for the sensor that has shown an abnormal data value. Inspection chart for diagnosis code (Refer to ).
|
|
|
|
- Remove the spark plug and install it to the ignition coil.
- Connect the ignition coil connector.
- Disconnect all injector connectors.
- At the engine start, check each spark plug produces a spark.
|
|
Q.
Is the check result normal?
|
|
Check Inspection Procedure - ignition circuit system (Refer to ).
|
|
|
|
- No. 1 injector connector
- No. 2 injector connector
- No. 3 injector connector
- No. 4 injector connector
- Injector check (Refer to ).
|
|
Q.
Are the check results normal?
|
|
Repair or replace the connector or replace the injector.
|
|
|
|
Q.
Is the check result normal?
|
|
- Fuel pressure test (Refer to )
|
|
Q.
Is the check result normal?
|
|
Q.
Is the check result normal?
|
|
Replace the timing chain.
|
|
|
|
- Check the compression pressure (Refer to GROUP 11A - On-vehicle Service - Compression Pressure Check ).
|
|
Q.
Is the check result normal?
|
|
- After replacing the engine-ECU, reconfirm whether the diagnosis code is stored.
|
|
Q.
Is the diagnosis code stored?
|
|
Check for foreign matters (water, diesel fuel, etc.) in fuel and replace if necessary.
|
|
|