|
- Data list reference table (Refer to ).
- Item AD: Oxygen sensor (rear)
|
|
Q.
Is the check result normal?
|
|
Intermittent malfunction (Refer to GROUP 00 - How to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunctions ).
|
|
|
|
- Disconnect connector, and measure at harness side.
- Ignition switch: "ON"
- Voltage between terminal engine-ECU ORLE line and body earth.
|
|
Q.
Is the check result normal?
|
|
- Check earthing line for open circuit.
|
|
Q.
Is the check result normal?
|
|
Repair or replace the connector, or repair the damaged harness wire.
|
|
|
|
- Data list reference table (Refer to ).
- Item AD: Oxygen sensor (rear)
|
|
Q.
Is the check result normal?
|
|
Intermittent malfunction (Refer to GROUP 00 - How to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunctions ).
|
|
|
|
- Check earthing line for damage.
|
|
Q.
Is the check result normal?
|
|
Repair or replace the connector, or repair the damaged harness wire.
|
|
|
|
- Use special tool test harness (MB991658) to connect connector, and measure at pick-up harness.
- Transmission: 2nd speed
- Drive with wide open throttle
- Engine: 3,500 r/min or more
- Voltage between terminal engine-ECU O2RL line and body earth.
|
|
OK:
The output voltage should be 1.1 - 1.5 V.
|
|
Q.
Is the check result normal?
|
|
- Oxygen sensor check (Refer to ).
|
|
Q.
Is the check result normal?
|
|
Repair or replace the connector, or check intermediate connectors, and repair if necessary. If intermediate connectors are normal, check and repair harness between oxygen sensor (rear) connector terminal and engine-ECU connector terminal O2RL.
- Check output line for short circuit.
|
|
|
|
Replace oxygen sensor (rear).
|
|
|
|
- Check output line for open circuit and damage.
|
|
Q.
Is the check result normal?
|
|
Repair the damaged harness wire.
|
|
|