REMOVAL AND INSTALLATION


Pre-removal and Post-installation Operation
  • Engine Upper Cover Removal and Installation (Refer to ).

<CAMSHAFT POSITION SENSOR>

Removal steps


1.
 Camshaft position sensor connector

>>A<<
 2.
 Camshaft position sensor

>>A<<
 3.
 O-ring

<CRANK ANGLE SENSOR>

Removal steps


·
 Air cleaner intake duct (Refer to GROUP 15 - Air Cleaner Assembly )


·
 Intercooler outlet air hose D (Refer to GROUP 15 - Intercooler )
<<A>>
1.
 Crank angle sensor and crank angle sensor connector


2.
 Crank angle sensor connector

>>A<<
 3.
 Crank angle sensor

>>A<<
 4.
 O-ring

REMOVAL SERVICE POINT

<<A>> CRANK ANGLE SENSOR AND CRANK ANGLE SENSOR CONNECTOR REMOVAL
With the crank angle sensor connector connected, remove the crank angle sensor and disconnect the connector.

INSTALLATION SERVICE POINT

>>A<< O-RING/SENSOR INSTALLATION
caution
  • Do not apply a force such as torsion or twist to the O-ring during assembly of the sensor.
  • Assemble the sensor, taking care not to give a shock to it.
  • Do not use a sensor that has been dropped.
1.Apply a small amount of engine oil to the O-ring.
2.Install the O-ring to the sensor with care to avoid damage to the O-ring.
3.Sufficiently remove the sealant attached to the crank angle sensor.

4.Apply the sealant to the crank angle sensor as shown in the figure.
Specified sealant: ThreeBond 1207D or equivalent
note Install the crank angle sensor immediately after applying sealant.
5.
caution After the installation, until a sufficient period of time (one hour or more) elapses, do not apply the engine oil or water to the sealant application area or start the engine.
Tighten the sensor to the specified torque.
Tightening torque: 9.5 ± 2.5 N·m