Code No. P2118: Throttle Valve Control DC Motor Current Malfunction

OPERATION

Current supplied from the engine-ECU connector terminal ETV- and ETV+ to the throttle valve control servo connector terminal is adjusted.

FUNCTION

The throttle valve control servo drive IC in the engine-ECU monitors current flowing in the throttle control servo and cuts energisation if it detects overcurrent.

TROUBLE JUDGEMENT

Check Condition

Ignition switch is in "ON" position.

Judgement Criterion

An overcurrent cut-off signal from the throttle valve control servo drive integrated circuit (IC) is repeatedly detected.

FAIL-SAFE AND BACKUP FUNCTION

The throttle valve is opened (electrical discontinuity).
The EGR control is stopped (fully closed).
The DPF regeneration is prohibited.

PROBABLE CAUSES

Failed throttle valve control servo
Short circuit in throttle valve control servo circuit or loose connector contact
Failed engine-ECU

DIAGNOSIS PROCEDURE

STEP 1. Check throttle valve control servo itself

Check throttle valve control servo itself (Refer to ).

Q. Is the check result normal?

	Go to Step 2.

	Replace the throttle body assembly.

STEP 2. Check of short to earth in ETV+ line between throttle body assembly connector and engine-ECU connector.

Q. Is the check result normal?

	Go to Step 3.

	Repair the connector(s) or wiring harness.

STEP 3. Check of short to earth in ETV- line between throttle body assembly connector and engine-ECU connector.

Q. Is the check result normal?

	Go to Step 4.

	Repair the connector(s) or wiring harness.

STEP 4. M.U.T.-III diagnosis code.

After clearing the diagnosis code through M.U.T.-III, start the engine and confirm whether the diagnosis code is set.

Q. Is the diagnosis code set?

	Replace the engine-ECU.

	Intermittent malfunction (Refer to GROUP 00 - How to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunctions).