|
1.Remove the engine room
under cover front B. (Refer to GROUP 51 - Under Cover
.)
|
|
2.
warning |
Hot steam may escape when the
radiator cap is opened.
Open with caution. Place rag over the cap and
twist it anticlockwise slightly to release the
pressure.
Wait until the hot steam is released, and then
remove the cap by turning it anticlockwise
gradually.
|
Drain the water from the radiator, heater core and
engine after unplugging the radiator
drain plug and removing the radiator cap.
|
![](../../../img/14/AC606073AF00ENG.png)
|
3.Disconnect the A/T
fluid cooler water feed hose B, and drain the coolant in the
water jacket. 4.Drain the coolant after unplugging
the radiator condenser tank. 5.After draining the
coolant, clean the path of the coolant by injecting water
into
the radiator from the radiator cap area. 6.Connect
the A/T fluid cooler water feed hose
B. 7.Securely tighten the drain plug of the
radiator. 8.Assemble the radiator condenser
tank.
|
![](../../../img/14/ACB05863AB00ENG.png)
|
9.Use special tool LLC
changer (MB991871) to refill the engine coolant up to the
top of
the radiator port.
Recommended
antifreeze: MITSUBISHI MOTORS GENUINE
SUPER LONG LIFE COOLANT PREMIUM or
equivalent*
note |
*similar high
quality ethylene glycol based
non-silicate, non-amine, non-nitrate
and non-borate coolant with long life
hybrid organic acid technology.
|
Quantity: Approximately 10.0 L (including
0.65 L in the radiator condenser
tank)
note |
For how to use special tool
(MB991871), refer to its manufacturer’s
instructions.
|
10.Tighten the radiator cap
securely. 11.Remove the radiator condenser tank
cap, and add the engine coolant up to the "FULL"
line of the level gauge. 12.Turn OFF the A/C
switch, start the engine to warm it up until the cooling
fan works.
note |
This is necessary to open the
thermostat fully.
|
13.Rev the engine several times and then stop
it. Check that there are no coolant
leaks. 14.Remove the radiator cap with the engine
cool, and then refill the engine coolant up
to the top of the radiator port. 15.Tighten the
radiator cap securely. 16.Remove the radiator
condenser tank cap, and add the engine coolant up to the
"FULL"
line of the level gauge. 17.Install the engine
compartment under cover front B. (Refer to GROUP 51 -
Under
Cover .)
|