|
Install the inlet manifold and the
injector protector front, and tighten mounting bolts
and nuts temporarily.
|
|
Make sure that the inlet manifold
stay is in intimate contact with the inlet manifold
and cylinder block boss before tightening it to the
specified torque of 20 ± 2 N·m.
|
|
1.Apply a small amount of
new engine oil to the O-ring.
|
|
2.Install the manifold
absolute pressure sensor and the purge control solenoid
valve
to the inlet manifold with care not to damage the
O-ring.
|
|
3.
caution |
Do not over-tighten. If the
mounting screw is over-tightened,
the inlet manifold can be damaged.
|
Tighten the mounting screws to the specified
torque. Tightening torque: 4.0 ± 1.0
N·m
|