REMOVAL AND INSTALLATION <6B3>



Pre-removal Operation
  • Engine Room Under Cover Front A and Engine Room Side Cover (RH) Removal (Refer to GROUP 51- Under Cover ).

Post-installation Operation
  • Alternator Drive Belt Tension Check (Refer to GROUP 11C - On-vehicle Service, Drive Belt Tension Check ).
  • Engine Room Under Cover Front A and Engine Room Side Cover (RH) Installation (Refer to GROUP 51 - Under Cover ).





Removal steps
<<A>>

1.
Alternator drive belt


2.
Alternator connector and terminal connection


3.
A/C compressor and clutch assembly connector connection
<<B>>

4.
A/C compressor and clutch assembly


5.
Compressor bracket


6.
Harness bracket
<<C>>
>>A<<
7.
Alternator assembly


8.
Harness bracket


9.
Earth cable connection


10.
Alternator upper bracket


11.
Alternator lower bracket

REMOVAL SERVICE POINTS



<<A>> ALTERNATOR DRIVE BELT REMOVAL



1.
caution When the alternator drive belt is reused, draw an arrow indicating the rotating direction on the back of the alternator drive belt using chalk to install the same direction.
Turn the alternator drive belt auto-tensioner to anti-clockwise, and insert the L-shaped hexagon wrench to the alternator drive belt auto-tensioner hole in order to fix the alternator drive belt auto-tensioner.
2.Remove the alternator drive belt.

<<B>> A/C COMPRESSOR AND CLUTCH ASSEMBLY REMOVAL


1.Remove the A/C compressor and clutch assembly from the A/C compressor bracket with the hose still attached.
2.Place the removed A/C compressor and clutch assembly where it will not be a hindrance when removing and installing the alternator assembly, and secure it with a cord or wire.

<<C>> ALTERNATOR ASSEMBLY REMOVAL


Move the A/C compressor and clutch assembly to one side, and then remove the alternator assembly from under the vehicle.

INSTALLATION SERVICE POINT



>>A<< ALTERNATOR ASSEMBLY INSTALLATION


1.Temporarily tighten the alternator assembly to the alternator bracket.

2.In accordance with the tightening order shown in the illustration, tighten the installation bolts for the alternator bracket to the specified torque.
Tightening torque: 47 ± 11 N·m