|
caution |
Do not clamp the yoke assembly
with a vise.
|
Disconnect the lead from the M terminal of the
magnetic switch.
|
|
1.Apply a long socket wrench
of an appropriate size to the stop ring and strike the
wrench to drive out the stop ring toward the pinion gear
side.
|
|
2.Remove the snap ring with
snap ring pliers, then remove the stop ring and overrunning
clutch.
|
|
1.Never clean in a solvent
such starter motor parts as the magnetic switch, brush
holder, and armature. If they are soaked in a solvent, their
insulation could be impaired. When these parts require
cleaning, wipe off contamination with cloth.
|
|
2.Never soak the drive unit
in a solvent. If it is washed in a solvent, the grease
having been packed in the overrunning clutch at the factory
will be washed out. Wipe the drive unit with cloth if it
requires cleaning.
|
|
Use a suitable puller to pull the
stop ring until it gets over the snap ring.
|