![](../../../img/16/AK802928AB00ENG.png)
|
caution |
Do not clamp the yoke assembly
with a vise.
|
Disconnect the lead from the M terminal of the
magnetic switch.
|
![](../../../img/16/AK304685AB00ENG.png)
|
1.Apply a long socket wrench
of an appropriate size to the stop ring and strike the
wrench to drive out the stop ring toward the pinion gear
side.
|
![](../../../img/16/AK802929AB00ENG.png)
|
2.After using the
screwdriver to remove to remove the snap ring, remove the
stop ring.
|
|
1.Never clean in a solvent
such starter motor parts as the magnetic switch, brush
holder, and armature. If they are soaked in a solvent, their
insulation could be impaired. When these parts require
cleaning, wipe off contamination with cloth.
|
|
2.Never soak the drive unit
in a solvent. If it is washed in a solvent, the grease
having been packed in the overrunning clutch at the factory
will be washed out. Wipe the drive unit with cloth if it
requires cleaning.
|
![](../../../img/16/AK802923AB00ENG.png)
|
1.Install the stopper ring
to the planetary gear shaft. 2.Install the snap
ring to the planetary gear shaft. 3.Pull the
planetary gear shaft to install the stopper ring to the
position shown in the illustration.
|