DATA LIST REFERENCE TABLE


caution
  • Road test always needs two people: one driver and one observer.
  • When shifting the selector lever to "D" position the brakes should be applied so that the vehicle does not move forward.
Item No.
Check item
Check condition
Normal condition
04
Vehicle speed signal
Road test the vehicle.
The speedometer and M.U.T.-III display the same value.
11
Accelerator pedal position sensor (main)
Ignition switch: "ON"
Release the accelerator pedal
900 - 1,100 mV
Depress the accelerator pedal gradually
Increases in response to the pedal depression stroke
Depress the accelerator pedal fully
4,000 mV or more
13
Throttle position sensor (main)

  • Remove the intake air hose at the throttle body
  • Disconnect the throttle position sensor connector, and then connect terminal numbers No. 3, No. 4, No. 5 and No. 6 with the use of the special tool: MB991658.
  • Ignition switch: "ON"

Fully close the throttle valve with your finger
300 - 700 mV
Fully open the throttle valve with your finger
4,000 mV or more
Engine: warming up, idling
No load
500 - 660 mV
A/C switch: "OFF" → "ON"
Voltage rises
Shift lever: "N" → "D"
57
Cancel code
Ignition switch: "ON"
The cancel code, which stored when the cruise control system was cancelled at the last time, is stored again.
74
Stop lamp switch (for stop lamp circuit)
Ignition switch: "ON"
Brake pedal: Depressed
ON
Brake pedal: Released
OFF
75
Cruise control switches (CANCEL switch)
Ignition switch: "ON"
CANCEL switch: Pressed
ON
CANCEL switch: Released
OFF
81
Cruise control operation
Cruise control: active
ON
Cruise control: Inactive
OFF
86
Cruise control switches (Cruise control ON/OFF switch)
Ignition switch: "ON"
Cruise control ON/OFF switch: Pressed
ON
Cruise control ON/OFF switch: Pressed again
OFF
88
Inhibitor switch
Ignition switch: "ON"
Selector lever: "N" or "P" position
ON
Selector lever: Other than "N" or "P" position
OFF
89
Brake switch (for cruise control circuit)
Ignition switch: "ON"
Brake pedal: Depressed
ON
Brake pedal: Released
OFF
91
Cruise control switches (RES + switch)
Ignition switch: "ON"
RES + switch: Pressed
ON
RES + switch: Released
OFF
92
Cruise control switches (SET - switch)
Ignition switch: "ON"
SET - switch: Pressed
ON
SET - switch: Released
OFF