Code No. P0893: Interlock Detection

DIAGNOSIS CODE SET CONDITIONS

With the stop lamp switch signal and output shaft speed sensor being normal, the fast deceleration exceeding the set time is detected.
Output failure to the solenoid, open or short circuit
Hydraulic switch pattern, hydraulic switch open or short circuit
Open circuit of the output shaft speed sensor or poor connection of the connector

Malfunction of the P0720: output shaft speed sensor system circuit
Damaged harness or connector
Malfunction of the P0743: lock-up and low-reverse brake linear solenoid valve system circuit
Malfunction of the P0753: low clutch linear solenoid valve system circuit
Malfunction of the P0758: 2-6 brake linear solenoid valve system circuit
Malfunction of the P0763: 3-5 reverse clutch linear solenoid valve system circuit
Malfunction of the P0768: high clutch linear solenoid valve system circuit
Malfunction of the P1753: low clutch shift solenoid valve system circuit
Malfunction of the P1758: low-reverse brake shift solenoid valve system circuit
Malfunction of the P0846: 2-6 brake pressure switch system circuit
Malfunction of the P0876: high clutch pressure switch system circuit
Malfunction of the P0988: low-reverse brake pressure switch system circuit

DIAGNOSIS PROCEDURE

Check if the following diagnosis codes are set.

	Go to Step 2.

	Repair or replace the failure section.

	Replace the A/T-ECU, and then go to Step 3.

	Repair or replace the failure section.

Check that the normal code is displayed.

	The procedure is complete.

	Replace the transmission assembly.