|
|
After the CVT assembly and the valve body assembly are replaced, their serial number and
learned value must be initialised. The initialisation procedure is as below.
|
|
|
1.Move the selector lever to the P range and turn the ignition switch to the "LOCK"
(OFF) position. Then, connect M.U.T.-III to the diagnosis connector.
|
|
|
2.Turn the ignition switch to the "ON" position, and then move the selector lever to
the R range.
|
|
|
3.Depress the accelerator pedal while depressing the brake pedal. (Engine stops.) Use
the M.U.T.-III special function to execute "Reset (item No.1: Control learning value)" while holding
them in applied position.
|
|
|
4.Set the selector lever to the P range.
|
|
|
5.Turn the ignition switch to the "LOCK" (OFF) position, and then wait for ten seconds.
|
|
|
6.Turn the ignition switch to the "ON" position. Execute the special function "CVT oil
degradation level (item No.1: Clear CVT oil degradation level)" on the M.U.T.-III to delete
a CVT fluid deterioration level.
|