|
While pressing A in the figure,
turn B anti-clockwise to unlock the CVT assembly connector,
and disconnect the connector.
|
|
Only loosen the bolts from the
engine and transmission assembly (do not remove).
|
|
1.Remove the coupling bolts
while turning the crankshaft.
|
|
2.Fully push the torque
converter into the transmission side so that it does not
remain on the engine side.
|
|
Remove the injector protector
mounting bolt (A shown in the illustration).
|
|
1.Tighten the engine hanger
plate (special tool: MB992853) to the specified torque at A
in the figure (injector protector rear mounting bolt) and B
in the figure (vacuum pipe assembly mounting
bolt). Tightening torque: 20 ± 2
N·m (A in the figure) Tightening torque: 11
± 1 N·m (B in the figure)
|
|
2.Assemble the engine hanger
(special tool: MB991527) with the chain of the engine hanger
balancer (special tool: MB991454).
|
|
3.<When engine hanger
(Special tool: MB991928) is used> (1)
Assemble the engine hanger (Special tool: MB991928). (Set
the components below to the base hanger.)
- Slide bracket (HI)
- Foot x 4 (standard) (MB991932)
(2)
Set the feet of the special tool as shown in the
figure.
|
note |
Adjust the engine
hanger balance by sliding the slide
bracket (HI).
|
|
(3)
Connect the engine hanger (Special tool: MB991928) to the
engine hanger (special tool: MB991527).Remove the garage
jack and then remove the transmission assembly upper part
coupling bolts that have been loosened previously.
|
|
4.<When engine hanger
(Special tool: MB991895) and engine hanger attachment
(Special tool: MB992906) are used> (1)
Set the foot of special tool engine hanger (MB991895) as
shown in the figure.
|
note |
Slide the front
foot of special tool engine hanger
attachment (Special tool: MB992906)
to balance the engine
hanger.
|
|
(2)
Connect the engine hanger (Special tool: MB991895) to the
engine hanger (special tool: MB991527).Remove the garage
jack and then remove the transmission assembly upper part
coupling bolts that have been loosened previously.
|
|
Fully push the torque converter
into the transmission side, and then assemble the
transmission assembly to the engine.
|
|
Tighten the injector protector
mounting bolt (A in the figure) to the specified
torque. Tightening torque: 20 ± 2
N·m
|
|
1.Move the selector lever to
the "N" range.
|
|
2.Move the manual control
lever to Neutral position.
|
|
3.Align the hole at the end
of the manual control lever and the hole in the inhibitor
switch body flange (section A - A).
note |
Insert a Φ5 mm bar into
the aligned holes in the inhibitor switch body
flange and on the tip of the manual control
lever to position the inhibitor switch body.
|
|
|
4.Use the adjusting nut to
tighten the transmission control cable to the specified
torque. Tightening torque: 9.5 ± 3.5
N·m 5.Make sure that the
transmission side ranges that are corresponding to the
selector lever position operate and function without
fail.
|