DIAGNOSTIC PROCEDURE |
STEP 1. M.U.T.-III CAN bus diagnostics |
Use M.U.T.-III to perform the CAN bus diagnosis. |
Q.
Is the check result normal?
|
Go to Step 2. |
|
Repair the CAN bus lines (Refer to GROUP 54C - Troubleshooting, Diagnosis
Code Chart ). |
|
STEP 2. M.U.T.-III data list |
Item 50: Brake switch |
OK: The service data changes in response to the brake operation. |
Q.
Is the check result normal?
|
Intermittent malfunction |
|
Go to Step 3. |
|
STEP 3. Stop Lamp Switch Check |
Refer to GROUP 35A - Brake Pedal and Stop Lamp Switch Continuity Check (Refer
to ). |
Q.
Is the check result normal?
|
Go to Step 4. |
|
Replace the stop lamp switch. |
|
STEP 4. Check for open circuit in STP line between the stop lamp switch connector and the ETACS-ECU connector |
Q.
Is the check result normal?
|
Go to Step 5. |
|
Repair the connector(s) or wiring harness. |
|
STEP 5. Check for open circuit or short to earth in BKLP line between the ETACS-ECU connector and the stop lamp switch connector |
Q.
Is the check result normal?
|
Go to Step 6. |
|
Repair the connector(s) or wiring harness. |
|
STEP 6. Symptom recheck after erasing diagnosis code |
Q.
Is the check result normal?
|
Intermittent malfunction |
|
Replace the ETACS-ECU, and then go to Step 7. |
|
STEP 7. Symptom recheck after erasing diagnosis code |
Q.
Is the check result normal?
|
Intermittent malfunction |
|
Replace CVT-ECU. |
|