|
After the new or repaired
transmission has been installed, fill to the proper level
with
MITSUBISHI MOTORS GENUINE CVTF-J4. The flow should be
checked using the following procedure:
|
|
1.Disconnect the cooler line
(A) at the transmission and place a collecting container
under
the disconnected line. 2.Run the engine at curb
idle speed with the selector lever in
neutral. 3.If transmission fluid flow is
intermittent or it takes more than 20 seconds to collect
1.0 L of transmission fluid, replace the CVT fluid cooler or
cooler line. 4.If flow is within acceptable
limits, reconnect the cooler line. Then fill the
transmission
to the proper level, using MITSUBISHI MOTORS GENUINE
CVTF-J4.
|