|
1.While pressing A in the
figure, turn B anti-clockwise to unlock the CVT assembly
connector,
and disconnect the connector.
|
|
2.
caution |
Insert a thermometer which is
made of metal or is put in a metal case (overall
length:
approximately 150 - 200 mm) into the
transmission case hole approximately 80
mm.
|
Remove the oil filler tube assembly (Refer to
Transmission Assembly), and insert a thermometer
into the transmission case hole.
note |
If a radiation thermometer
(noncontact thermometer) is available, use it to
measure the surface
temperature of the oil pan.
|
3.Measure the resistance between the
sensor-side connector terminal No. 17 of the CVT
assembly connector and the earth (terminal
No.19). Standard value:
|
Fluid
temperature
(°C)
|
Resistance
kΩ
|
0
|
Approximately
15.5
|
20
|
Approximately
6.5
|
40
|
Approximately
3.1
|
60
|
Approximately
1.6
|
80
|
Approximately
0.9
|
100
|
Approximately
0.5
|
|
4.
caution |
The CVT fluid temperature
sensor cannot be removed or
replaced as a single unit. When the CVT fluid
temperature sensor needs to be replaced, replace
the valve body assembly.
|
When the resistance of the CVT fluid temperature
sensor is outside the standard value,
and the fluid temperature warning comes on/goes out at
other than the specified temperatures,
replace the valve body assembly and the harness.
|