|
1.While pressing A in the
figure, turn B anti-clockwise to unlock the CVT assembly
connector,
and disconnect the connector.
|
|
2.
caution |
Insert a thermometer which is
made of metal or is put in a metal case (overall
length:
approximately 150 - 200 mm) into the
transmission case hole approximately 80
mm.
|
Remove the oil filler tube assembly (Refer to
Transmission Assembly), and insert a thermometer
into the transmission case hole.
note |
If a radiation thermometer
(noncontact thermometer) is available, use it to
measure the
surface temperature of the oil pan.
|
3.Measure the resistance between the
sensor-side connector terminal No. 12 of the CVT
assembly connector and the earth (terminal No.
18). Standard value:
|
Fluid
temperature
(°C)
|
Resistance
kΩ
|
20
|
6.29 -
6.83
|
50
|
2.10 -
2.25
|
80
|
0.85 -
0.90
|
|
4.Measure the resistance between the
sensor-side connector terminal No. 12 of the CVT
assembly connector and the transmission
case. Normal condition: No
continuity 5.
caution |
The CVT fluid temperature
sensor cannot be removed or replaced
as a single unit. When the CVT fluid temperature
sensor needs to be replaced, replace the valve
body harness.
|
When the resistance of the CVT fluid temperature
sensor is outside the standard value,
replace the valve body harness. (Refer to )
|