note |
- It may take approximately one minute that the data of tyre pressure change is displayed
on the M.U.T.-III screen.
- If the data of tyre pressure change is not displayed on the M.U.T.-III screen, the
most possible cause is that the radio wave sent from the TPMS transmitter cannot be received.
In this case, the radio wave may be received by performing the procedures from (1) again after
turning the tyre to change the TPMS transmitter position. If the tyre pressure change is still
not displayed on the M.U.T.-III screen, the TPMS transmitter in which the ID code is not registered
may be installed, or the TPMS transmitter may be faulty. Therefore, perform ID code registration
or replace the TPMS transmitter according to the instructions of troubleshooting for diagnosis codes.
(At this time, do not register the ID codes or replace the TPMS transmitter.)
|