Code No. C1564: Vehicle speed data invalid
|
caution |
- If diagnosis code No. C1564 is set, diagnose the CAN bus lines.
- When replacing the ECU, always check that the communication circuit is normal.
|
|
|
If the ETACS-ECU <Vehicles without KOS> or KOS-ECU receives an abnormal vehicle speed signal from the ABS-ECU <Vehicles without ASC> or ASC-ECU <Vehicles with ASC>, it sets diagnosis code No. C1564. When the ETACS-ECU <Vehicles without KOS> or KOS-ECU receives an abnormal vehicle speed signal consecutively with the engine switch in the ON position, the ECU determines that there is a failure.
|
|
- Malfunction of CAN bus line
- Damaged wiring harness and connector
- Malfunction of ABS-ECU <Vehicles without ASC> or ASC-ECU <Vehicles with ASC>
- Malfunction of ETACS-ECU <Vehicles without KOS> or KOS-ECU
|
|
STEP 1. M.U.T.-III CAN bus diagnostics
|
|
Use M.U.T.-III to diagnose the CAN bus lines.
|
|
Q.
Is the check result normal?
|
|
Go to Step 2.
|
|
|
|
Repair the CAN bus lines (Refer to GROUP 54C - Troubleshooting). On completion, go to Step 2.
|
|
|
|
STEP 2. Check whether the diagnosis code is set again.
|
|
(1)Turn the ignition switch (engine starting switch) from the "LOCK" (OFF) to "ON" position.
|
|
(2)Check if the diagnosis code is set.
|
|
Q.
Is the diagnosis code set?
|
|
Go to Step 3.
|
|
|
|
The procedure is complete.
|
|
|
|
STEP 3. M.U.T.-III other system diagnosis code
|
|
Check if the diagnosis code is set in the ABS-ECU <Vehicles without ASC> or ASC-ECU <Vehicles with ASC>.
|
|
Q.
Is the check result normal?
|
|
Go to Step 4.
|
|
|
|
NO <Vehicles without ASC> : Carry out the troubleshooting for ABS-ECU (Refer to GROUP 35B - Diagnosis code chart).
|
|
|
|
NO <Vehicles with ASC> : Carry out the troubleshooting for ASC-ECU (Refer to GROUP 35C - Diagnosis code chart).
|
|
|
|
STEP 4. Check whether the diagnosis code is set again.
|
|
(1)Turn the ignition switch (engine starting switch) from the "LOCK" (OFF) to "ON" position.
|
|
(2)Check if the diagnosis code is set.
|
|
Q.
Is the diagnosis code set?
|
|
Replace the KOS-ECU (Refer to GROUP 42B - KOS-ECU ) <Vehicles without KOS> or ETACS-ECU (Refer to GROUP 54A - ETACS-ECU ) and register the ID codes.
|
|
|
|
The procedure is complete.
|
|
|